Can we disable the blue LEDs blinking?

dims · August 10, 2015, 11:25pm

Is there a way that we could disable or, at least, control the way blue LEDS of SC are blinking?

Thanks in advance!
dims

guillem · August 13, 2015, 1:31pm

Please,

follow the documentation here:

fablabbcn/smartcitizen-kit/blob/master/sck-commands.md

## SCK Serial Commands

The Smart Citizen Kit can be managed over a basic serial protocol. You just need the **Arduino IDE Serial Monitor** or any other **Serial Utility** like **Screen** in order to use it.

#### How to use it.

* Connect to your kit using any serial utility, any baud-rate should work but `115200` is recommendable.
* Send the starting commands.
* Notice all the commands except the starting commands require a carriage return at the end: `CR` or `\r`  .
* Call any command you want, change `XXX` with the corresponding value.

### Basic SCK setup commands

This commands are commands to talk directly to the Wi-Fi module (RN-XV WiFly) own interface.

* `$$$`							Wake up the module and enter WiFly commands mode
* `set wlan ssid XXX\r`        Add a new SSID to memory
* `set wlan phrase XXX\r`      Add a new phrase to memory
* `set wlan key XXX\r`         Add a new key to memory
* `set wlan auth XXX\r`        Add an authentication method into memory

This file has been truncated. show original

In order to run the set sys iofunc 0x7 described there.

This should disable the Wi-Fi activity blue LED’s.

Please come back to us if you have any issues.

Guillem